Paring Bluesonic with iPhone

Well I had some trouble with paring to iPhone 3G, it takes very long time and sometimes doesn't work at all, so I decided to try with iPhone fimware 3.0 beta, and that works great, it can take while, several minutes and a few attempts but finally it works.

Heres a method I found to be working very well, this is with iPhone firmware beta 4:

1. Turn on your master helmet.
2. Turn off your slave helmet (if you have one).
3. Set your master helmet to slave by pressing <Helmet 2> button on the remote.
4. Turn on bluetooth on the iPhone and wait until it's activated and you can see that it is searching for devices.
5. Now set your helmet (the one that used to be master) to master again by pressing <Helmet 1> button on remote.

Wait until the iPhone asks for PIN, enter: 1234 and press connect, after a few seconds they will pair.

If you have a second helmet:
Now turn on you slave helmet.
On you master helmet press <Helmet 2> and then <Helmet 1>, now your iPhone and slave helmet will connect.

The above also works with Beta 5 firmware.

Also if the above procedure does not work, turn all your stuff off, then turn them on again, master-helmet last and then just wait for a few minutes, now they probably will connect.